So, I have been running my No 14 for a while now, and she is running quite sweetly. However, ever since I have had her I have found that it can be quite hard to change into forward gear. I didn't notice this when she was in manual mode as it took quite a bit to get the reverser lock to release.
However, since I have fitted a servo to the reverser, I notice that it seems to go in almost constant strain to get her into forward gear. Putting in reverse is fine, but there is a definite resistance when sliding into forward gear. I can usually get the strain off the servo by just putting it a touch back towards mid gear, but I would rather cure the problem full stop.
And before anyone asks no the servo isn't throwing to the full extent of the expansion link. This is more a resistance to set the gear into the forward direction which doesn't appear when putting into reverse.
I was just wondering if anyone else had a similar experience before I send an e-mail off to Accucraft? I'm rather hoping its a easy fix rather than having to send the engine away.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum